Skip to content

Drill Output

LinkCAD 11 writes Excellon drill files from the Gerber RS-274X exporter (Gerber/ODB++ option). This page describes what LinkCAD 11 does; the behavior of LinkCAD 10 is not covered here.

How It Works

When the Gerber export writes one file per layer (the default; Single file off), every layer whose output name ends in .drl is written as an Excellon drill file instead of a Gerber file. Upper and lower case do not matter. All other layers are written as Gerber.

On a drill layer:

  • Each circle becomes a drill hit at its center, with its diameter as the tool size
  • Each donut becomes a drill hit at its center, with its inner diameter as the tool size
  • Other geometry on the layer (polygons, polylines, arcs, text) is not written

Each distinct diameter gets its own tool (T01, T02, …).

File Format

  • Header M48 with INCH,LZ: inch units, leading zeros
  • Coordinates in absolute 2.4 format
  • A tool table, then % and G05 (drill mode), the hits per tool, and M30 at the end

The format is fixed; it does not follow the Gerber coordinate-digit setting.

Steps

  1. Put the holes on their own layer, drawn as circles (or donuts).
  2. Give that layer an output name ending in .drl, for example drill.drl.
  3. Export as Gerber RS-274X with one file per layer.
  4. Check the drill file in your CAM tool before fabrication: hole count, tool sizes and position relative to the copper layers.

See also: Gerber RS-274X.